Car TalkCar MaintenanceCar TiresHow To Fix Tire Pressure Sensor Fault?

How To Fix Tire Pressure Sensor Fault?

Most of the time, the fix a faulty tire pressure sensor is pretty simple. It might just need a manual reset after you fill the tires, or perhaps the sensor battery has finally died and needs replacing. Don't ignore the light, even if your tires look fine!

Is that annoying Tire Pressure Monitoring System (TPMS) light still on, even after you checked your tires and filled them up? A flashing light usually means the sensor itself is broken or needs a reset, not that your tire is flat. Don’t worry, we’ll show you the easiest ways how to fix tire pressure sensor fault, whether it needs a simple reset or a full replacement.

What Does Tire Pressure Sensor Fault Mean?

The message regarding faults in the pressure sensors indicates a problem with one or more of the tire pressure monitoring system (TPMS) sensors in a vehicle. TPMS sensors are installed in the tires and are responsible for monitoring the air pressure levels. They send signals to the vehicle’s computer system, which then displays the tire pressure readings on the dashboard. 

tire pressure monitoring system
One of the primary symptoms of a faulty pressure sensor is incorrect or inconsistent pressure readings (Photo: istockphoto)

The error code tells whether the pressure sensor is faulty, or the air pressure in the tires is too high or too low.

When the tire pressure sensor is going too badly, it will provide inaccurate readings. A defective TPMS control unit or frayed wiring could be the culprit, too. Sometimes, you can fix the problem

Just by resetting the TPMS, but replacement is the only option in some cases.

Symptoms Of A Faulty Pressure Sensor

The sensor is an electrical component so it can be damaged for plenty of reasons like age, dirt, heat, and irregular power supply. Some of the high or low tire pressure sensor fault symptoms are:

1. Incorrect readings

One of the primary indications of a faulty pressure sensor is incorrect or inconsistent pressure readings. The sensor may provide readings that are significantly higher or lower than the actual tire pressure. This can be observed through the tire pressure monitoring system (TPMS) display on the dashboard or with a separate tire pressure gauge.

2. A warning light on the dash

A malfunctioning pressure sensor can trigger the TPMS warning light on the dashboard. The warning light may appear as a symbol resembling a tire with an exclamation mark or the letters “TPMS.” This light generally indicates a fault in the tire pressure monitoring system.

tire pressure warning light
The warning light may appear as a symbol resembling a tire (Photo: istockphoto)

3. False alarm

The car dashboard continuously shows warning alerts (indicating low tire pressure when the tires are actually properly inflated) but the tire is still in a normal condition. In addition, it is possible that when the tire pressure and temperature change, the parameters displayed on the screen remain unchanged.

4. Inconsistent behavior

A malfunctioning pressure sensor can cause irregular behavior in the TPMS. For instance, the readings may fluctuate frequently or display different values ​​each time the vehicle is started or during driving.

When the tire pressure sensor is faulty, the driver can handle this problem by resetting or replacing the sensor. If the sensor does not receive the signal, you should replace the sensor valve with a new one. To know more about the detailed steps, let’s move to the next part to find out:

How To Fix Tire Pressure Sensor Fault?

Check tire pressure manually

Before starting the repair process, you have to make sure that all the tires have the correct air pressure. There’s a label behind the driver’s door that shows the right tire pressure for your car. You can find the same information in the repair manual. Check the tires with a pressure gauge to find out if they have the right level of air pressure.

In the case of overinflation, release some air until it falls to the correct level. Pump up the air if the tires are underinflated. Fill up with a bit more pressure than mentioned on the label when the tires are warm because high temperatures lower the pressure of pressure.

For example, if the tire pressure label says 240 kpa, the TPMS will show an error code when the pressure goes below this level. If you fill the tire up to 240 kpa when the tires are hot, the pressure may go down to 220 kpa when they are cold.

The repair manual shows how to reset the TPMS in your car. Some models have a reset button. Just push it after filling up the tires with the correct pressure. You may need to drive some cars for at least 15 minutes for the warning lights to go off.

checking car tires
You have to make sure that all the tires have the correct air pressure (Photo: istockphoto)

Inspect the tire pressure sensor 

Visually inspect the tire pressure sensors for any visible damage, such as physical impact, corrosion, or loose connections. Ensure that the sensors are securely mounted on the valve stems of the tires. 

If the tire pressure sensor is found to be faulty and cannot be repaired, it may need to be replaced. Faulty sensors typically require professional assistance to ensure proper installation and calibration. A qualified technician can diagnose the faulty sensor using specialized diagnostic tools and replace it with a new sensor if necessary.

Replace the sensor battery 

Generally, the average lifespan of the sensor battery will last from 2 to 6 years depending on the position of the sensor valve. After this period of time, if the sensor valve does not transmit data to the car dashboard, your sensor may have run out of battery. 

When the sensor valve runs out of battery, the letter “L0” will appear at the parameter display position corresponding to that valve’s position. A sign that the tire pressure sensor is out of battery is that one or more sensors do not send a signal to the controller. So if the tire pressure sensor uses a replaceable battery, it may be necessary to replace the battery.

Watch more:

Conclusion: Time to Turn Off That Light

Dealing with a faulty Tire Pressure Monitoring System (TPMS) light is definitely annoying, but it’s important to remember why it’s there: to keep you safe.

Most of the time, the fix is pretty simple. It might just need a manual reset after you fill the tires, or perhaps the sensor battery has finally died and needs replacing. Don’t ignore the light, even if your tires look fine! By using these easy steps to diagnose and repair the fault, you can get rid of that dashboard warning and keep your car monitoring your safety the way it should.

Tsukasa Azuma
Tsukasa Azuma
Tsukasa Azuma is the resident car expert at Car From Japan. He owns a car repair shop in downtown Osaka, and his years of hands-on experience shine through in his informative blog posts. Tsukasa provides top-notch car maintenance tips and keeps readers up-to-date on the latest trends in the auto industry, offering a unique and insightful perspective on everything car-related. His blog has become a go-to resource for anyone wanting to keep their car in top shape.
RELATED ARTICLES

LEAVE A REPLY

Please enter your comment!
Please enter your name here

referral program

Most Popular