Windshield Wipers NOT Returning Rest Position: Here is How to Fix It

The windshield wiper ensures that you get a clear vision while driving. But, what if the windshield wipers not returning rest position? This could be a bit tricky but not impossible to handle. Here you will find out the easiest and most effective method to get the windshield wipers back to the normal position.

Let’s check it out now!  

Windshield Wipers Not Returning Rest Position: What to Do

During the driving process, there must have been many drivers who experienced heavy rain and dense fog blocking visibility. Understanding the driver’s issue, to ensure the safest for the driver and passengers in the car, car wipers were developed.

The windshield wiper is a part attached to the windshield of the car, used to remove dirt, water, and fog, and to clear the driver’s vision when driving. The design of the wipers is quite simple, but they are “small but mighty” giving a lot of benefits to the driver on all roads. We can see that the windshield wipers are an extremely necessary and indispensable part of your vehicle. Therefore, you should carefully check this part to be able to identify unexpected problems and failures and replace them in time.

Over time, the wiper when subjected to the effects of the environmental factors or external effects will inevitably be damaged or broken. A stuck windshield wiper can be a common problem many drivers encounter while driving. But don’t worry! We will share with you simple steps to handle this problem. 

Fix your jammed wipers in minutes by following the step-by-step procedure.

1. Clean the windshield

One of the most common reasons behind windshield wiper not returning rest position is dust and debris. The micro dust particles on the windshield glass get collected on wiper pads. Whenever you run the wipers, they get jammed at a certain position. So, clean the windshield so that the debris is removed if there is any.

 Read more:

2. Take away the driver-side wiper    

Next, what you have to do is to open the hood of the car. To do that, open the driving seat door. Now look for the latch underneath the steering wheel, pull it carefully. It’s so easy to recognize the latch as it has an image of the hood.

When you successfully open the hood, it’s time to remove the driver-side wiper. For that purpose, you will require a screwdriver using which you can detach the wiper. Gently, pull it off and set it aside. Now, check the wiper for any faults. The replacement would be required in case of any fault.

Windshield wipers not returning rest position
The windshield wipers not returning the rest position. bit tricky but not impossible to handle.

3. Pull off the foam stripe & plastic cap

You can get back the wiper to its resting position by reaching the transmission. Reaching the transmission is easy by removing a few of the equipment. Firstly, you have to remove the foam, which is placed inside the driver-side wiper (that you removed earlier). Remember, you do not have to remove the entire foam. Take the partial foam out only. Now, slowly and carefully pull away from the plastic caps thereafter remove the plastic cover partially. Here, you will be able to see the transmission.

4. Locate the transmission

So, you have reached the transmission! You are almost done with the task. Just locate the transmission in the parallel position which will help to place the wipers in symmetry. Turn on the car and run the wiper until they come to their resting position. Once the wipers are in the rest position, turn off the engine.

The next and last step involves hitting the tab. So, grab a flathead screwdriver and a hammer to get things done. Pliers would work too. Make sure that you hit the tab until it gets to the point where the transmission locks it. Now, test the wipers whether they are repaired or not. If it’s working well and setting back to rest after turning it off, you are good to go. But, if it’s still sticking to some position, keep on moving the tab until it’s done.

Windshield wipers not returning rest position
The windshield wipers not returning the rest position. ensures at you get clear vision while driving

In the end, place everything back collectively.

Check out this video to know more windshield wiper tips:

Conclusion

Many factors can be the reason for the windshield wipers not returning rest position. Moreover, you can use the above four-step guide and the best maintenance tips to fix the wipers and prevent future issues.  

 If you have any car questions, just leave us a comment below.