5 Great Small Ding Repair Tips
No matter how cautiously drive a car, there will always be dings. However, ding repair jobs are simple and easy. You can follow the ding repair guide below and complete a ding repair job in no time.
Ding Repair: Is It Necessary?
You may wonder whether dings and dents are the same on the car or not. Dings are classified as small dents that do not penetrate the paint or expose the metal underneath. Ding marks are typically up to 0.5 inches in diameter and seem not to have effects on your vehicle’s paint.
Unlike dings, car dents are more serious damage. Dings are much more insignificant than dents. They often occur from being hit by a shopping cart, a parked car door opening into your car, or possibly from small debris thrown up while driving. Hail is also a fairly common cause of screeching noises. Although dings are just small dents sometimes, this mark can affect the whole appearance of your car. And due to a small thing, it’s easy to be overlooked while making a maintenance process by drivers.
Over time, unwanted collisions will inevitably occur. Whether it is an objective or subjective factor, the car’s body will have some slight dings. If you don’t want to waste money, car owners can apply the following methods to handle dings themselves and limit damage to the paint layer…
Car Ding Repair: 5 Tips You Should Follow
Referring to these tips below to give your car a better exterior:
Tip #1
Inspect the damage carefully. You can fix the ding without leaving any sign of previous damage if the metal is not crumpled or creased.
Tip #2
Dry ice is effective against dings. Use a hair dryer to heat an area and push dry ice against it. Keep it that way for a few seconds. The principle of this method is the same as pouring boiling water and then pouring cold water to cause the temperature to change and the plastic will pop out and return to its original shape. Once the area is warm, gently push the dent out from the inside or use a plunger to pull it out from the outside. This method can work for soft dents on plastic or metal surfaces. Follow this procedure over and over again, until the ding completely fades away. Before touching dry ice must wear safety gloves to avoid injury to your hand.
Tip #3
A suction cup can pull the dings out and put the debts back in line. Clean the area properly before applying a suction cup. Any remaining particles can damage the painting and disrupt the suction process.
Tip #4
Tapping is another way to rid your car of unsightly dings and dents. A block of wood and rubber mallet in proportionate to the size of the ding can be used to tap the ding back in its due place. Use a cushioning fabric or towel to wrap the device you are going to use.
Tip #5
A paintless repair job is another way to remove dings without spending a lot. A mechanic will use designated tools to fix the damaged spots and bring back the previous smoothness and look of the design.
Though dings in your car are enough to give you sleepless nights, removing them is relatively easy. It is an easily doable DIY. But if you find the dings larger, seek professional help to eliminate those without damaging your car. Having the dings fixed at an auto repair shop should not cost you a fortune, though.
In cases, where you can’t fix dings by yourself, take your car to the mechanic for help:
The steps for treating dings on cars are still basically based on the heat impact method.
- For plastic parts, the repair technician will use enough heat to impact the hardness and elasticity of the plastic to return them to their original shape, then repaint the surface if there is damage.
- For high-hardness steel or aluminum parts, repair will be complicated, requiring specialized equipment to return them to their original shape.
We hope that all these tips may help you handle this problem easily.
Watch more:
