How to Install Spark Plug Non-Fouler in Your Car?
Every month, eighty out of hundred people send half of their money on car repairing and maintenance. But, a few things like installation of spark plug non-fouler can be done by yourself. To accomplish that, all you need is the right method that would lead you to the successful installation of spark plug non-fouler. Here you will get to know about the best method for the spark plug anti-fouler installation in your vehicle. Let’s check it out now!
The best way to install Spark Plug non-fouler
Installing the spark plug non-fouler could be a typical thing to do but not when it’s done in the right way. But, before you start the entire installation procedure, don’t forget to have all security tools near you. So, let’s get started!
1. Fit the sensor
Your car can have room for either one or two spark plug non-fouler. If you want to install more than one spark plug, it’s preferable to have an electric drill machine by your side. When you are out to buy the spark plug, go for at least eighteen mm size. To begin the installation, reset your ECU (Engine Control Unit) by disconnecting the negative terminal on the battery. Drill down the center of one non-fouler to the half by taking it out. Doing this would make enough space for the sensor to fit inside it easily.
- Denso or NGK- Which spark plug to choose for your car?
- Which is the right way to read the spark plug color?
2. Screw park plug & Unscrew sensor
After successfully locating the sensor inside spark plug non-fouler, screw it to the tight on the crest of the original. To make the whole setup easy to remover, it is useful to use or apply an anti-grab product on the strand. Now, carefully detach the stock sensor, place cell stick in, and again use some anti-grab. Take a paper towel or any cleaning product to dirt-free the entire cell. Make sure that you don’ t leave a single spot from cleaning as it might result in further issues.
>> You are interested in an used car from Japan, buy now <<
3. Reinstall & Reconnect
Take the sensor and reinstall it by applying some anti-grab on the thread. Now, it’s time to reconnect the entire ECU system that is the battery of your car. Voila! You have just installed the entire spark plug non-fouler system by yourself. In case, you want to make the installation fail proof, use the maintenance tips as well. If you have too tight non-fouler, this entire method is the thing to try.
In a Nutshell
You can save your money and time by this useful DIY method to install spark plug non-fouler. But, in worst case scenario, don’t think too much to call the professionals as they can handle the situation better. So, follow this easy way to have a safe, sound, and inexpensive driving experience for the lifetime.
Use it now!