Find. Buy. Drive
CAR FROM JAPAN - Find best deals of used cars from reliable Japanese sellers

How to Program Dodge Key Fob Without a Working One

If you want to replace the key fob of a new Dodge car, knowing the key fob programming becomes essential. But when there is no working key available, the situation becomes complex. The only thing you can do is learn how to program dodge key fob without a working one and perform the steps accordingly.

How to Program a Dodge Key Fob

The procedure to program a Dodge key fob involves some simple steps that you can perform as per the following guideline.

  1. Enter into the Dodge car of any model and sit on the driver’s seat. Within the range of 10 seconds, press and release the “LOCK BUTTON” of the key fob five times. In this step, timing is crucial.
  2. Now, press the “UNLOCK BUTTON.” While holding it, insert the key into the car ignition and turn it in the ignition to “RUN” mode. Do not take your finger off of the “UNLOCK BUTTON.”
  3. While pressing down the “UNLOCK BUTTON,” do the same on the “PANIC BUTTON” for one full second. Then, release both buttons together.
  4. Now, hold down the “UNLOCK” and “LOCK” buttons together before releasing them simultaneously.
  5. Once again, press the “UNLOCK BUTTON.”
  6. Now, the Dodge car should recognize the key fob.
programming dodge key fob
Programming a Dodge key fob is an easy task. (Source: Quote Inspector)

How to Program Dodge Key Fob Without a Working One

If the key fob is not working, it becomes more difficult to program it. However, there is also a solution to this issue called Manual Programming Procedure that does not need a scan tool.

Step 1: Connect pin 1 or pin 4 of the 16-way data link connector to chassis ground.

Step 2: Shut all the vehicle doors and turn off the ignition key.

Step 3: Turn the ignition key to the Accessory position.

Step 4: Now is the time to turn off the ignition. As a result, door locks will cycle for one time in programming mode.

Step 5: For every key FOB, press any button three times in a row to execute the code programming.

Step 6: After the completion of the programming, the door locks cycle will take place once again.

SEE MORE

What If the Battery of the Key Fob Is Dead

Sometimes, the key fob battery is dead or has too low charge to function. In that situation, try this trick to open the Dodge vehicle doors:

The good news is, there will always be a hidden key inside the fob. To locate it, flip the fob to get to its opposite side and slide the switch of the top left corner to pull out the silver key. Now, this key can easily unlock the car doors.
Place back the key inside the key fob for its security purpose.

Push the start button with the Dodge key fob and press the brake with your feet.

Conclusion

If you are curious to know how to program dodge key fob without a working one, follow these steps. Thus, it should be an easy process to program a Dodge key fob. But it is also possible for the newbies to face a problem. In that case, take suggestions from the expert Dodge vehicle specialists.

Leave A Reply

Your email address will not be published.